欧美在线精品日韩国产_国产日韩在线视看高清视频手_国产00高中生在线无套进入_少妇熟女精品中文字幕_亚洲免费视频久久_欧美一卡在线影院_免费看的黄色小视频_拔萝卜又叫又疼的原声_在办公室揉制服护士乳动态图_亚洲免费播放片丝袜国产

XYH-P01 PREPREG (UL ANSI:FR-4.0)

環氧玻纖布半固化片

PP 規格 Prepreg specifications

以上為我司常規規格,可根據客戶要求生產

The above is the regular specifications of our company, which can be produced according to the customer's
requirements

儲存條件 Storage Condition
■在溫度小于 20℃，濕度小于 50%可存放 90 天；小于 5℃條件下可存放 180 天。
20℃, 50%RH for90 days ；max 5℃ for 180 days.

壓合概論 Lamination Overview
■PP 應在堆疊室內進行，避免吸濕。
Stacks must be prepared in lay-up room to avoid moisture absorption.
■疊合好的 PP 與芯板壓合開始時建議最小保持 60 分鐘的抽真空狀態。
Stacks with the core and prepreg is recommended to use the vacuum process for 60min when being heated.

建議壓合條件

Recommended Press Cycle

升溫過程                                             ■  Heating
a. 溫度范圍為 80-120℃                        a.Temperature Range=80-120℃
b. 升溫速率為 1.4-2.5℃/ 分鐘               b. Rate:1.4—2.5℃/min
注意：這些數值僅供參考，當機器和材料結構不同時這些值可能做調整

Note: these values are reference only they may change depending on machine and material structure

■ 為使樹脂固化完全，料溫在 170-180 度最小保持 30 分鐘
Temperature of material in 170-180℃ must be held for at least 30mins to make the epoxy solidify
completely.
■ 為避免板彎翹，冷壓時材料在 100℃以上時冷卻速率保持在 2.5℃/min 以下。
Cooling rate of material should be kept under 2.5℃/min when the temperature of material is over
100℃,in order to avoid introducing twist.